Hello
I have done some searching on the internet but not having much luck, but I am convinced this question has been asked somewhere...
I am 22, 5'10 and 215lbs and my target is to lose at least 25 lbs in the next few months hitting it hard first and then gradually changing my workouts to a more manageable sustainable level for the future when I hit my target weight. I am going to go into some detail for the next bits now.
I have done a 60 minute cardio session on the cross trainer (elliptical) yesterday and with my heartrate monitor (I have one with my age, weight, vo2 max set up) said I lost roughly 500 calories. My heart rate was between 144 and 158 throughout the exercise but I thought it was a bit overkill as I kept to around 75% of max HR 196 (this was the lowest max HR I got from two ways I was told to calculate it so I use this as worst case scenario) and I didnt sweat much.
Today I decided to change gears and do interval training and did 60 minutes again excluding a 5 minute warm up and 5 minute warm down. I did a 90s work 90s recover workout for a total of 20 intervals and I felt fantastic, and my body felt great so I thought this was the best way forward. The problem is I dont know if I am doing it right, because I scanned through a lot of info on the internet and the numbers that stuck for me are 75% recover and 90% work so here is what I did:
5 minute warm up to a HR of 135-137, the Xtrainer set to level 3 (of 16). I set my breathing pattern to 2 full revs in, 2 full revs out.
Interval training started with 90s work to raise HR to 175 (90% max). I increased resistance to level to 9 for this bit. Breathing changed to 1 rev in 1 rev out for the rest of the exercise. Then followed this with a 90s recovery level 3 again maintaining the breathing to hit a 137 HR.
19x more then I did a 5 minute warm down from the last 90s recovery to get my heart rate to 125 and normalised my breathing, again resistance 3.
The problem is everything online implied you should absolutely kill it for the 90s work period but I didnt/couldnt do that because after 50 seconds I hit my target max 175 and then I hold that HR for the remainder of the 90s which involves keeping the resistance up but slowing down the revs, ergo not "killing it". Once the 90s period is over I relieve the strain and continue with a low rev which is probably 20-40% effort for me to get my HR down in the 90s. Am I doing this right? I think I am because the alternative I think would be to get to 175 and then reduce resistance but continue with the high rpm. Either way I was sweating buckets and the way I did it felt great, I just want to make sure it is right and will work, not break my body.
I have done some searching on the internet but not having much luck, but I am convinced this question has been asked somewhere...
I am 22, 5'10 and 215lbs and my target is to lose at least 25 lbs in the next few months hitting it hard first and then gradually changing my workouts to a more manageable sustainable level for the future when I hit my target weight. I am going to go into some detail for the next bits now.
I have done a 60 minute cardio session on the cross trainer (elliptical) yesterday and with my heartrate monitor (I have one with my age, weight, vo2 max set up) said I lost roughly 500 calories. My heart rate was between 144 and 158 throughout the exercise but I thought it was a bit overkill as I kept to around 75% of max HR 196 (this was the lowest max HR I got from two ways I was told to calculate it so I use this as worst case scenario) and I didnt sweat much.
Today I decided to change gears and do interval training and did 60 minutes again excluding a 5 minute warm up and 5 minute warm down. I did a 90s work 90s recover workout for a total of 20 intervals and I felt fantastic, and my body felt great so I thought this was the best way forward. The problem is I dont know if I am doing it right, because I scanned through a lot of info on the internet and the numbers that stuck for me are 75% recover and 90% work so here is what I did:
5 minute warm up to a HR of 135-137, the Xtrainer set to level 3 (of 16). I set my breathing pattern to 2 full revs in, 2 full revs out.
Interval training started with 90s work to raise HR to 175 (90% max). I increased resistance to level to 9 for this bit. Breathing changed to 1 rev in 1 rev out for the rest of the exercise. Then followed this with a 90s recovery level 3 again maintaining the breathing to hit a 137 HR.
19x more then I did a 5 minute warm down from the last 90s recovery to get my heart rate to 125 and normalised my breathing, again resistance 3.
The problem is everything online implied you should absolutely kill it for the 90s work period but I didnt/couldnt do that because after 50 seconds I hit my target max 175 and then I hold that HR for the remainder of the 90s which involves keeping the resistance up but slowing down the revs, ergo not "killing it". Once the 90s period is over I relieve the strain and continue with a low rev which is probably 20-40% effort for me to get my HR down in the 90s. Am I doing this right? I think I am because the alternative I think would be to get to 175 and then reduce resistance but continue with the high rpm. Either way I was sweating buckets and the way I did it felt great, I just want to make sure it is right and will work, not break my body.